Holybro  |  ID: H-R2-45

Holybro PM06D Power Module (14S)

$49.99
Frais d'expédition calculés à l'étape de paiement.

1 en stock
15020-C2

PM06D provides a regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6-pin cable. It has built-in power distribution, allowing you to power your ESC and FC with the same board.

The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 14S. The Power Module comes completely assembled with an XT60 connector and a capacitor. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.

Package Includes:

1x PM06D Power Module

1x 6-pin 2.00mm pitch cable

NOTICE:

PM06D is supported by PX4. For Ardupilot, it is supported in version 4.4 and later. 

This PM uses I2C digital signal data output and is not compatible with flight controller that uses analog PM such as the Pixhawk 6C & Mini, Pixhawk4 & Mini, pix32 v5, or Durandal flight controllers.

Specifications:

Input voltage: 2S- 14S

PCB Cont. Current Rating: 70A

PCB Burst Current Rating: 120A (<60 Sec)

Max current sensing: 327A

Voltage and current monitor with I2C compatible interface 

Connector Outputs: 5.2V and 3A max 

Weight: 24.5g

Retours

Consultez notre politique de retour ici.

Questions sur les produits

Contactez-nous via la bulle de chat dans le coin inférieur droit, et nous vous répondrons dans les plus brefs délais !

Estimer les frais d'envoi

Citations d'entreprise

Besoin d'un devis pour un produit commercial ? Contactez-nous ici.

Suggestions de produits

Vous ne savez pas quel drone est le plus adapté à vos besoins ? Contactez-nous par e-mail ou via la bulle de discussion avec vos questions.

Démonstrations d'entreprise

Vous achetez un drone commercial et souhaitez une démonstration ? Contactez-nous pour plus d'informations.