Holybro  |  ID: H-R2-45

Holybro PM06D Power Module (14S)

$49.99
Shipping calculated at checkout.

1 in stock
15020-C2

PM06D provides a regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6-pin cable. It has built-in power distribution, allowing you to power your ESC and FC with the same board.

The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 14S. The Power Module comes completely assembled with an XT60 connector and a capacitor. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.

Package Includes:

1x PM06D Power Module

1x 6-pin 2.00mm pitch cable

NOTICE:

PM06D is supported by PX4. For Ardupilot, it is supported in version 4.4 and later. 

This PM uses I2C digital signal data output and is not compatible with flight controller that uses analog PM such as the Pixhawk 6C & Mini, Pixhawk4 & Mini, pix32 v5, or Durandal flight controllers.

Specifications:

Input voltage: 2S- 14S

PCB Cont. Current Rating: 70A

PCB Burst Current Rating: 120A (<60 Sec)

Max current sensing: 327A

Voltage and current monitor with I2C compatible interface 

Connector Outputs: 5.2V and 3A max 

Weight: 24.5g

Returns

Visit our return policy here.

Product Questions

Contact us via the chat bubble in the bottom right corner, and we will respond as soon as possible!

Estimate shipping

Enterprise Quotes

Need a quote for a commercial product? Get in touch with us here.

Product Suggestions

Not sure what drone is right for your needs? Contact us via email or the chat bubble with your questions.

Enterprise Demos

Purchasing a commercial drone and want a demonstration? Contact us for more information.